Floor Sanding and Cleaning Tips For the Perfect Finish
Floor Sanding located in Adelaide is the procedure of eliminating the surface top of a wooden floor with liquid sand by physically sanding using abrasive materials at a certain pressure. It is one of the most effective ways of polishing and removing floor stains and other marks. It can also be done on marble, granite, linoleum, carpet, hardwood floors and other surfaces subject to normal wear and tear. The sandpaper used in floor sanding should be wet/dry sandpaper or sandpaper specifically manufactured for floor sanding. An orbital sander will make the work easier and faster, but it will be less precise.
For screening hardwood floors, the first step is to clean the wood’s surface with a bleaching solution (such as the Magic Eraser) or white spirit. After this is done, you can start sanding the wood with the appropriate sandpaper. A high-speed, fully automatic sander is advisable for this purpose. In Floor Sanding located in Adelaide, you will need to avoid sharp edges.
Floor Sanding located in Adelaide requires several accessories such as a drum sander, a floor polisher, a power saw, a framing square, a trowel, sandpaper and a finishing felt pad. You should perform all these tasks in stages, taking care to sand in the wood grain direction. The first stage of sanding involves removing any surface finishes, such as varnish or wax. It can be done by gently scraping the finish away with the drum sander. After this is done, you can start sanding the floor at a rate of about three to six inches per day, taking care to sand in the same direction.
The next step in the process is to apply the floor polish or floor sanding product. If using a power saw, you need to be very careful while using it, and you must be extra cautious when handling the sandpaper. To be on the safe side, it is advisable to wear ear, eye, and mouth protection. A floor polisher helps to make the floor look as good as new.
Once the floor is sanded and a polyurethane finish, it is time to apply the polyurethane finish. Again, it is advisable to wear ear, eye, and mouth protection because of the possibility of particles getting into your eyes. Apply the finish evenly, paying special attention to the edges. Some particles may escape from your sight. If this happens, re-sand the floor in the same direction and with the same amount of sandpaper.
When hardwood-floor cleaners are used on a stained surface, the chemical causes a reaction that changes the colour of the wood. However, the colour can be changed back once the finish dries out. Some stains require that the wood is painted over before it can be restored. Before painting, make sure you use only water-based water-proof paints. To see an even finish and to avoid drips, it is advisable to leave the finish dry. Some stains can be cleaned using the furniture polish remover, but this is not recommended if the stain is water-based.